The Ketland proof or maker's mark was used by Ketland family to mark Trade Guns on the barrel. This mark was typically placed between the view and proof marks on the off flat of the breech.
The inspector's mark is about .275" wide, about .400" tall, and the tool body is 2-1/2" length, 1/2" diameter, brightly polished steel, hardened to Rc 62 to 65 (as hard as a file). Wrap the body with masking tape to provide a better grip.
Made in the USA, of very hard steel, this tool will give a long life, if used correctly.
Be careful, be safe. If mis-struck, this steel marking punch can become a projectile. Wear safety glasses. Protect your fingers.
Our instructions are included with each tool. Or click the download tab to view, and print these step-by-step instructions as a .pdf file.
Marks on rounded or flat steel surfaces require multiple strikes, in sequence. Marks in wood require only one controlled strike.
No Return, No Refund, No Exchange. Steel marking punches are expendable hardened steel tool bits, with a service life similar to drill bits or hand taps. The value is in the first use. Longevity is under the control of the user. We do not offer a warranty nor a refund for these tools. They are an investment for future use.
Never attempt to mark tempered steel, plated steel, or case-hardened steel with these hand stamps.
The inspector's mark is about .275" wide, about .400" tall, and the tool body is 2-1/2" length, 1/2" diameter, brightly polished steel, hardened to Rc 62 to 65 (as hard as a file). Wrap the body with masking tape to provide a better grip.
Made in the USA, of very hard steel, this tool will give a long life, if used correctly.
Be careful, be safe. If mis-struck, this steel marking punch can become a projectile. Wear safety glasses. Protect your fingers.
Our instructions are included with each tool. Or click the download tab to view, and print these step-by-step instructions as a .pdf file.
Marks on rounded or flat steel surfaces require multiple strikes, in sequence. Marks in wood require only one controlled strike.
No Return, No Refund, No Exchange. Steel marking punches are expendable hardened steel tool bits, with a service life similar to drill bits or hand taps. The value is in the first use. Longevity is under the control of the user. We do not offer a warranty nor a refund for these tools. They are an investment for future use.
Never attempt to mark tempered steel, plated steel, or case-hardened steel with these hand stamps.
Adobe Reader required to view the files below.
hand-stamp-instructions.pdf
Last updated: 8/15/2008 (955 KB)
page_110.pdf
Last updated: 4/25/2012 (144 KB)
page_207.pdf
Last updated: 4/25/2012 (181 KB)
page_260.pdf
Last updated: 4/25/2012 (136 KB)