This percussion lock was made by Thompson Center, for their Greyhawk rifle. It is the same design as the lock used on Hawken, Renegade, New Englander, White Mountain Carbine, and Pennsylvania Hunter rifles, except in stainless steel, and could be used on those rifles. The photo is representative! This used lock is in perfect working order, very good condition.
Right hand, the lock plate and hammer are factory engraved. This is a later T/C locks with the curled finger spur, and they require the new short nipple.
This lock has a powerful coil mainspring, fly detent for use with double set triggers, and it is tapped for an 8-32 lock bolt, sold separately.
Right hand, the lock plate and hammer are factory engraved. This is a later T/C locks with the curled finger spur, and they require the new short nipple.
This lock has a powerful coil mainspring, fly detent for use with double set triggers, and it is tapped for an 8-32 lock bolt, sold separately.
LOCK-TC-BR
Bridle, wax cast, drilled, Thompson Center Hawken lock
LOCK-TC-BX
Bridle screw, .225", 6-48 thread
LOCK-TC-FL
Fly detent, wax cast steel, tempered, Thompson Center Hawken lock
LOCK-TC-HA-L-USED
Hammer,
Thompson Center Hawken or Renegade,
late style curled hammer, used
LOCK-TC-HA-USED
Hammer,
Thompson Center Hawken or Renegade,
early style straight hammer, used
LOCK-TC-MS
Mainspring, tempered, coil style, Thompson Center Hawken lock
LOCK-TC-MSP
Mainspring plunger, tempered, Thompson Center Hawken lock
LOCK-TC-SE
Sear, wax cast steel, tempered, with integral axle Thompson Center Hawken lock
LOCK-TC-TU
Tumbler, wax cast steel, tempered, right hand,
Thompson Center Hawken percussion and flint locks
LOCK-TC-TX
Tumbler Screw, 6-40 thread, hammer screw, blued, for all models of Thompson Center locks
