The photograph shows this trigger in the "set" position. This "double lever" set trigger has a front trigger lever to engage the sear, so the lock can be fired with the trigger unset. The trigger bar is about .400" wide and 5-1/4" long. Wax cast steel parts are finished, tempered and assembled. We stock spare parts, in the unlikely event that any part will ever break. Same day shipment of trigger spare parts.
This trigger is a precision assembly made with heat treated tool steel. If either trigger must be bent to fit the triggerguard, heat the trigger to a cherry red and bend while hot. Reharden by heating to cherry red and quenching in 10W oil or mineral oil. Temper by heating to 550 degrees for 1 hour in a kitchen oven. The trigger bar can be bent slightly without heating.
The trigger bar is about .400" wide and 5-1/4" long.
This trigger is a precision assembly made with heat treated tool steel. If either trigger must be bent to fit the triggerguard, heat the trigger to a cherry red and bend while hot. Reharden by heating to cherry red and quenching in 10W oil or mineral oil. Temper by heating to 550 degrees for 1 hour in a kitchen oven. The trigger bar can be bent slightly without heating.
The trigger bar is about .400" wide and 5-1/4" long.
TR-DST-1-FTS
Front trigger spring, tempered steel, fits several double set triggers
TR-DST-1-MS
Trigger mainspring, tempered steel, fits several double set triggers
TR-DST-1-MSX
Trigger mainspring screw, 3/8", 6-40 thread, fits several double set triggers
TR-DST-1-TAX
Trigger adjustment screw, 3-48 thread, fits several double set triggers
TR-DST-4-FT
Trigger, front, tempered steel, for #TR-DST-4 double set triggers
TR-DST-4-PL
Trigger plate, for DST-4 trigger, as cast, plate only, .400" wide
TR-DST-EA-RT
trigger, rear, tempered steel, for #TR-DST-EA double set triggers
Adobe Reader required to view the files below.
page_350.pdf
Last updated: 4/25/2012 (83 KB)