This three piece set includes a horn valve (#HVM), pouring spout (#SP-000) and bushing (#HVB).
Our brass horn valve is threaded to accept the pouring spout or our calibrated charger spouts. Our threaded brass bushing simplifies installation of the valve. Simply glue it into your horn's neck, providing a strong 3/8-24 thread. The bushing fits a 15/32" diameter hole. Our threaded flask funnel (#Funnel-FL) fits this valve to easily refill your powder horn.
Our brass horn valve is threaded to accept the pouring spout or our calibrated charger spouts. Our threaded brass bushing simplifies installation of the valve. Simply glue it into your horn's neck, providing a strong 3/8-24 thread. The bushing fits a 15/32" diameter hole. Our threaded flask funnel (#Funnel-FL) fits this valve to easily refill your powder horn.
BOOK-MMA
Making Muzzleloading Accessories
by R. H. McCrory
BOOK-PHAA
Powder Horns and Their Architecture,
by Madison Grant
FILE-SET-NEEDLE
Needle Files,
set of 12,
6-1/4" long
HORN-STAPLE-L
Powder Horn Staple, Large,
7/8" wide hand forged iron,
with decorative twist
HORN-STAPLE-S
Powder Horn Staple, Small,
5/8" wide hand forged iron, with decorative twist
HORN-STRAP
Horn strap leather lace, 5/32" wide, 72" long
LACE-LATIGO-3
Latigo leather strap, 3/8" wide, 54" long
SP-SET
11 Piece Powder Flask Spout Set,
brass, 10-1mm thread to fit most common flasks
Adobe Reader required to view the files below.
powder-measure-valve.pdf
Last updated: 4/21/2014 (3 MB)