Our wax cast alloy steel kit parts require filing, grinding, drilling, polishing, fitting and assembly. Triggers are annealed and may be bent before hardening and tempering. If you have never attempted to harden and temper a steel part, this can be an easy introduction. Use a small propane torch for hardening, and a kitchen oven for tempering. Drilling, tapping and polishing, and assembly can quickly be accomplished. Skilled use of a drill press will be a plus. Problems? Any lost or damaged part can be replaced from our stock of spare parts.
Overall length 5-1/2", width .400".
Overall length 5-1/2", width .400".
PIN-3-32
Steel Dowel Pin, 3/32" diameter, 1-1/4", hardened, for lug, pipe, guard, or trigger pivot pin
TR-DST-1-MS
Trigger mainspring, tempered steel, fits several double set triggers
TR-DST-1-MSX
Trigger mainspring screw, 3/8", 6-40 thread, fits several double set triggers
TR-DST-1-TAX
Trigger adjustment screw, 3-48 thread, fits several double set triggers
TR-DST-6-FT
Trigger, front, tempered steel, for #TR-DST-6 double set triggers
TR-DST-6-FTS
Front trigger spring, tempered steel, fits several double set triggers
TR-DST-6-PL
Trigger plate, for DST-6 trigger, as cast, plate only, .400" wide
TR-DST-GA-RT
trigger, rear, tempered steel, for #TR-DST-GA double set triggers
Adobe Reader required to view the files below.
page_348.pdf
Last updated: 4/25/2012 (93 KB)