This .54 caliber Thompson Center Hawken percussion rifle is very lightly used. This factory finished rifle is stocked in American black walnut with brass furniture, and blued 28" straight octagon barrel. The bore is bright and has been well maintained. Weight is 8.8 pounds, and with a trigger reach of 14-1/4", the rifle is perfectly setup for today's average sized shooter.
The factory polished blued barrel is .54 caliber, 1" octagon, 28" length. The blue finish displays some wear at the muzzle from firing, but otherwise appears to be in near new condition. The front sight is Thompson Center's blued steel bead sight. The rear sight is click adjustable for elevation, and screw adjustable for windage. The bore is bright and clean, with crisp rifling grooves. We recommend our .530" round ball, .015" lubricated patch, over a charge of 70 grains of GOEX FFg black powder. This rifle pre-dates the QLA muzzle and the bore is rifled all the way to the end of the muzzle.
The American black walnut stock is stained to a warm brown. The stock appears to be as new with dents or dings. The patchbox, nosecap, and triggerguard are brass, which have just started to mellow. The wooden ramrod is fitted with a brass tip threaded 10-32 to accept loading and cleaning accessories. The ramrod is retained by two round brass pipes. The single lock bolt has a round brass washer-style side plate. The beaver tail cheek piece is shaped for a right hand shooter.
Our top view shows the hooked breech, which allows the barrel to be easily dismounted for cleaning without risk of wetting the stock with water containing black powder residue. To dismount the barrel, put the lock on half cock, withdraw the ramrod, drift the key past the underlug, and the barrel can be lifted from the barrel channel for ease of cleaning. Remove the nipple and place the breech end of the barrel in a bucket of soapy water. Run a wet patch down and up the bore, the pumping action will flush all the fouling from the barrel. Once the bore is clean, run a dry patch down the bore to pick up any moisture followed by a oily patch. Dry and oil the exterior then reassemble the rifle.
Our lock view shows the color case hardened percussion lock, factory engraved by Thompson Center. This lock works smoothly, with a strong mainspring, and fly detent to allow the use of double set triggers. Correctly adjusted, you may cock the lock, or set the trigger, in any sequence. Turn the tiny set trigger adjustment screw, between the two triggers, inboard to reduce the set trigger release tension. Or turn it fully inboard, to disable the set trigger feature, when hunting in very cold climates, where a numb finger might release the light set trigger too early.
A very lightly used T/C Hawken with a bright bore. It will serve you well in the woods this Fall or at the range! Order it for a ten day visual inspection. You will be delighted. Else if it does not fit you, return it in unfired condition for same-day refund. Postage is your only risk, when you order any one-of-a-kind gun from Track, whether new, used, or antique.
The invite trades, and we buy T/C guns. If you have a used Thompson Center Seneca, Hawken, Cherokee, Renegade, Patriot Pistol, New Englander, or other muzzle loading side hammer rifle, please consider our service when you are ready to sell. Our customers like these well made American guns, for their reliable service, durable reputation, accuracy, and good value. Order this gun today!
|
|
bullets, .54 caliber, T/C Maxi-Ball, hand cast pure lead, 425 grains, per 20
|
|
|
|
.530" round balls, pure lead, Hornady, per 100
|
|
|
|
Track's best Black Powder BORE CLEAN Solvent, with flip-top spout
|
|
|
|
Ball puller, steel screw, .54 caliber brass collar, 10-32 thread
|
|
|
|
Bore brush, bronze, for .54 caliber, 10-32 thread
|
|
|
|
Brass Capper, for No. 11 caps, straight line, made in the USA, by Tedd Cash
|
|
|
|
Fouling Scraper, flat face, brass, .54 caliber, 10-32 thread
|
|
|
|
Nipple, Hot Shot® for Thompson Center Hawken & other popular guns, 1/4-28 thread, #11 CCI cap, stainless steel
- Cone length: 0.440"
- Thread journal length: 0.195"
- Overall length: 0.635"
- Diameter of base: 0.307"
|
|
|
|
Jag, jagged cleaning tip, brass, .54 caliber, 3/8" rod, 10-32 thread
|
|
|
|
Powder measure, brass, adjustable 0 to 120 grains, with spout
|
|
|
|
Trapper's MINK OIL TALLOW,
patch grease,
for match shooting & cold weather hunting,
one 8 oz. tin
|
| Part Number:
|
MINK-OIL
|
| Availability:
|
|
|
Price:
|
$8.59
|
|
|
|
Shooting patches, .015" cotton, .50 - .59 caliber, per 100, dry
|
|
|
|
Cleaning Patches, 2-1/2" diameter, bag of 100, pure cotton flannel, for .45 to .58 caliber
|
|
|
|
Ramrod, 3/8" hickory, 48" long, brass tip, 10-32 thread
Ramrods cannot be send to a P O Box.
|
|
|
|
Ramrod for Thompson Center Hawken, Cabela's Hawken, Investarm Hawken,
3/8" brown Delrin nylon, 28-5/8", flared brass tip, threaded 8-32 at front, 10-32 at rear.
Made in the USA by Track of the Wolf, Elk River, Minnesota.
|
|
|
|
Short Starter, patch & ball starter, 1/2" wooden rod for .54 and larger calibers.
|
|
|
|
Patch puller, corkscrew worm, steel, brass base, 10-32 thread
|
|