Taps, high speed steel, 6-1mm thread
Plug taps have three to five threads chamfered, to cut threads in a through hole, or to start threads in a blind hole, closed at the bottom.
Tap Drills are smaller in diameter than the screw shaft to leave enough metal to cut threads.
Clearance Drills are large enough to allow the body of the bolt to pass through the hole.
Recommended Tap Drill: for 6-1mm thread, use metric Drill-5mm
Tap Drills are smaller in diameter than the screw shaft to leave enough metal to cut threads.
Clearance Drills are large enough to allow the body of the bolt to pass through the hole.
Recommended Tap Drill: for 6-1mm thread, use metric Drill-5mm
TAP-6-1MM-P
Tap, high carbon steel, 6-1mm thread, plug tap
TAP-6-1MM-T
Tap, high carbon steel, 6-1mm thread, taper tap
TAP-W-10
Tap handle, accepts #10 to 1/4" diameter taps
