This long-range 5" Creedmoor Vernier tang sight includes two pivoting adjustment screws in the base, to allow perfectly true Vertical alignment, without file fitting the base to your tang.
This sight does have windage adjustment, built in. You may loosen the eye disk, and slide the eye-disk carriage vane from side-to-side, for windage. Be sure to scribe a zero mark, since the vane is unmarked.
Two 4-7mm mounting screws are included. Base mounting holes are 1.510" on center. Made in Italy, this sight is often fitted to Pedersoli Rolling Block Rifles, or Sharps rifles by Pedretti, EMF, IAB, Siles, or Powder River.
Blued steel, over 5" tall, a detent spring locks it upright, unless folded down. Vernier elevation markings are engraved on the side. Record your 100, 200, 300, 400, 500 and 1000 yard settings in your notebook, for each bullet you use.
Click ADD TO CART, for same day shipment. Ten day inspection begins at delivery. Else return it for same day refund, if not delighted. Postage is your only risk.
This sight does have windage adjustment, built in. You may loosen the eye disk, and slide the eye-disk carriage vane from side-to-side, for windage. Be sure to scribe a zero mark, since the vane is unmarked.
Two 4-7mm mounting screws are included. Base mounting holes are 1.510" on center. Made in Italy, this sight is often fitted to Pedersoli Rolling Block Rifles, or Sharps rifles by Pedretti, EMF, IAB, Siles, or Powder River.
Blued steel, over 5" tall, a detent spring locks it upright, unless folded down. Vernier elevation markings are engraved on the side. Record your 100, 200, 300, 400, 500 and 1000 yard settings in your notebook, for each bullet you use.
Click ADD TO CART, for same day shipment. Ten day inspection begins at delivery. Else return it for same day refund, if not delighted. Postage is your only risk.
Adobe Reader required to view the files below.
page_248.pdf
Last updated: 4/25/2012 (120 KB)