This Ruger New Model Single Six revolver only has the cylinder for the .22 Long Rifle cartridge with a 5-1/2" barrel. This revolver is finished to a dark blue. The blue finish has holster wear with edges worn bright as well as other areas that appear to be abraded bright. on the frame and cylinder. This revolver qualifies for FFL transfer and can be picked up by a Minnesota resident, or it must be shipped to a FFL dealer in another state.

The 5-1/2" round barrel is fitted with a fixed blade front sight. A brass overlay has been added to the sight to increase the width. A notch in the top of the frame forward of the hammer works as a rear sight for the gun. This notch has been scrubbed bright. The hammer spur is grooved to give the shooter a secure grip when cocking the revolver. To the rear of the fluted cylinder the loading gate of the revolver can be seen. The gate can be opened to extract empty shells and load fresh rounds, it must also be open for removal of the cylinder. The right hand side of the barrel houses the ejector rod to remove spent cartridges. A final look at the revolver shows off the factory markings on the barrel and the frame. The frame reads RUGER .22 Cal over New Model Single Six.. The factory warnings are under the barrel on this example. The checkered black rubber grips have the Ruger emblem.

The revolver is used with some marks in the finish. It has the gray plastic case and manual. The bore is bright and it has been well maintained. This revolver qualifies for FFL transfer and can be picked up by a Minnesota resident, or it must be shipped to a FFL dealer in another state.