Shaped but not mortised for a lock, this Hawken fullstock is modeled after the early work of Jacob and Samuel Hawken, with an early square cheekpiece, not the later beavertail found on halfstocks. We strongly recommend straight grain maple for large bores. Shaped for a left hand shooter, with 15/16", or 1" straight octagon barrel channel. The stock will accept barrels up to 42" in length. All 15/16" stocks have a 3/8" ramrod hole drilled full depth, while 1" stocks have a 7/16" ramrod hole drilled full depth. All stocks have a shaped forend. The buttplate is uncut. Order our Hawken plans to help layout and design this project.

Drop is about 3-1/2" from the line of sights. The stock is not cut for a buttplate, so you may adjust the trigger reach, up to about 15" length. The butt end is about 4-15/16" x 1-5/16", for our early wide Hawken buttplate. Lock panels are shaped, with no lock mortise cut, hand inlet your flint or percussion lock. Not cut for the tang hand inlet a long Hawken hooked breech, straight, flared, or your own custom shaped breech plug. Not inlet for a specific trigger, hand inlet your favorite single or set trigger in this nice stock.

Specifications for non-inlet stocks:

• Drop and trigger reach: drop is 3-1/2" from the line of sights to heel, at 15" of pull
• Barrel channel size: 15/16", or 1" straight octagon, up to 42" length
• Butt end: 1-5/16" wide by 4-15/16" high, not cut for buttplate
• Lock & Trigger: uncut
• Ramrod hole & groove: 3/8" diameter for 15/16", 7/16" for 1", drilled full depth