Center Punch,
1/4" diameter,
for marking drilling operations
Part Number: DRILL-CP-14
Availability: Out of Stock, request notification when available.
Price: $4.99
The center punch has a included point angle of 90 degrees and is used to mark the workpiece prior to drilling operations. Locate the spot where you will drill a hole. Give the punch a blow with a hammer to create a pointed impression. This small depression helps prevent the drill point from "walking" during drilling operations.
Adobe Reader required to view the files below.
Get Adobe Reader
page_396.pdf Last updated:4/25/2012 (116.64 KB)
Track of the Wolf, Inc.
18308 Joplin St NW
Elk River, MN 55330-1773

For your convenience you can contact us via our on-line form
Contact the Webmaster if you have any problems with this site.
Privacy Policy        Copyright © 2019Track of the Wolf, Inc.
Accepted Credit Cards