T/C New Englander,
.50 caliber, 26" barrel, QLA muzzle,
percussion, walnut, iron,
used, from a kit by Thompson Center Arms
Part Number: AAT-287
Availability: In Stock
Price: $425.00
Order Quantity:
This Thompson Center New Englander .50 caliber rifle is stocked in black walnut with a color case hardened percussion lock, and tapered round barrel. This rifle was assembled from a kit, with a factory blued barrel. The lock engraving has been accented with a gold wash. The bore is bright and the oiled finished stock shows only a few minor handling marks from use. Trigger reach is 14" to fit today's average size shooter. Weight is 7.5 pounds.

The .50 caliber rifled barrel is 26" tapered round. The bore is rifled with a 1 in 48" twist to shoot a patched round ball, or T/C Maxi ball with good accuracy. The muzzle has Thompson Center's QLA (Quick Load Accurizer) feature. The QLA is a relief of the rifling, the first inch of the barrel has no rifling, allowing loads to be easily started and quickly loaded. The bore is bright and has been well maintained. The barrel bluing on the exterior is in excellent condition. The barrel is fitted with a patridge front sight and an elevation adjustable rear sight. We note the rear sight has JB weld applied, so the sight cannot be adjusted for windage.

Our front view shows the American black walnut stock. Assembled from a kit, the stock was given an oiled finish. There are a couple runs in the finish along the bottom of the forearm. The stock has a few minor handling marks from use, but is in overall good condition. The barrel channel has been glass bed on both sides of where the underlug is located. We note the toe of the buttstock has a unfilled screw hole where a sling swivel stud was once installed. The blued steel trigger guard is attached with two small blued steel wood screws. The bow is large to accept a gloved finger when hunting.

The hooked breech allows the barrel to be easily dismounted for cleaning without risk of wetting the stock with water containing black powder residue. To dismount the barrel, put the lock on half cock, withdraw the ramrod, drift the key past the underlug, and the barrel can be lifted from the barrel channel for ease of cleaning. Remove the nipple and place the breech end of the barrel in a bucket of soapy water. Run a wet patch down and up the bore, the pumping action will flush all the fouling from the barrel. Once the bore is clean, run a dry patch down the bore to pick up any moisture followed by an oily patch. Dry and oil the exterior then reassemble the rifle. The wooden ramrod is fitted with blued tips, and the hidden end is threaded to accept 10-32 cleaning and loading accessories.

Our lock view shows the color case hardened percussion lock, factory engraved by Thompson Center. The engraving has been accented with a gold wash. This lock works smoothly, with a strong mainspring. The single trigger provides a smooth release of the lock. The breech is fitted with a 1/4-28 stainless steel Hot Shot nipple.

This Thompson Center New Englander Rifle will serve you well both in the field and at the range. With a bright bore, it is ready to shoot! Order it for a ten day visual inspection. You will be delighted. Else if it does not fit you, return it in unfired condition for same-day refund. Postage is your only risk, when you order any one-of-a-kind gun from Track, whether new, used, or antique.

This American made rifle is a good value. We invite trades, and we buy T/C guns. If you have a used Thompson Center Seneca, Hawken, Cherokee, Renegade, Patriot Pistol, New Englander, or other muzzle loading side hammer rifle, please consider our service when you are ready to sell. Our customers like these well made American guns, for their reliable service, durable reputation, accuracy, and good value.

Ready to order? Click VIEW CART in the upper right of the screen, review items and quantities, then click CHECK OUT. Enter your name, address, and billing information for prompt shipment. Or, PRINT your order after entering your address, attach your check or money order, and send it by mail. Shipping cost is displayed after you enter your address.

Our web site displays actual in stock status, up-to-the-minute price, and shipping cost to every address in the USA and MOST OTHER COUNTRIES. International shipping cost for extra long or heavy parcels are determined after we weigh the parcel.

Ten day inspection begins at delivery. Send your approval. Else return it for same day refund, if not delighted. Postage is your only risk.

bullets, .50 caliber, Hornady Great Plains, 385 grain, pure lead, hollow base, hollow point, per 20
bullets, .50 caliber, Hornady Great Plains, 385 grain, pure lead, hollow base, hollow point, per 20
Part Number: BALL-50-385
Availability: Out of Stock, request notification when available.
Price: $11.19
  
bullets, .50 caliber, T/C Maxi-Ball, hand cast pure lead, about 378 grains, per 20
bullets, .50 caliber, T/C Maxi-Ball, hand cast pure lead, about 378 grains, per 20
Part Number: BALL-50-MAXI
Availability: In Stock
Price: $10.99
Order Quantity:
.490" round balls, pure lead, Hornady, per 100
.490" round balls, pure lead, Hornady, per 100
Part Number: BALL-490
Availability: Out of Stock, request notification when available.
Price: $14.29
  
Track's best Black Powder BORE CLEAN Solvent, with flip-top spout
Track's best Black Powder BORE CLEAN Solvent, with flip-top spout
Part Number: BORE-CLEAN
Availability: In Stock
Price: $4.09
Order Quantity:
Ball puller, steel screw, .50 caliber brass collar, 10-32 thread
Ball puller, steel screw, .50 caliber brass collar, 10-32 thread
Part Number: BP-50-10
Availability: In Stock
Price: $3.75
Order Quantity:
Bore brush, bronze, for .50 caliber, 10-32 thread
Bore brush, bronze, for .50 caliber, 10-32 thread
Part Number: BRUSH-50-10
Availability: In Stock
Price: $2.99
Order Quantity:
Brass Capper, for #11 caps, straight line, made in the USA, by Tedd Cash
Brass Capper, for #11 caps, straight line, made in the USA, by Tedd Cash
Part Number: CAPPER-P
Availability: In Stock
Price: $10.99
Order Quantity:
Nipple, Hot Shot® for Thompson Center Hawken & other popular guns, 1/4-28 thread, #11 CCI cap, stainless steel

Cone length: 0.440" Thread journal length: 0.195" Overall length: 0.635" Diameter of base: 0.307"
Nipple, Hot Shot® for Thompson Center Hawken & other popular guns, 1/4-28 thread, #11 CCI cap, stainless steel
  • Cone length: 0.440"
  • Thread journal length: 0.195"
  • Overall length: 0.635"
  • Diameter of base: 0.307"
Part Number: HOT-SHOT-RST
Availability: In Stock
Price: $6.99
Order Quantity:
Jag, jagged cleaning tip, brass, .50 caliber, 3/8 rod, 10-32 thread
Jag, jagged cleaning tip, brass, .50 caliber, 3/8 rod, 10-32 thread
Part Number: JS-50-6-10
Availability: In Stock
Price: $4.25
Order Quantity:
Powder measure, brass, adjustable 0 to 120 grains, with spout
Powder measure, brass, adjustable 0 to 120 grains, with spout
Part Number: MAS-120
Availability: In Stock
Price: $18.99
Order Quantity:
Trapper's MINK OIL TALLOW,
patch grease,
for match shooting & cold weather hunting,
one 8 oz. tin
Trapper's MINK OIL TALLOW, patch grease, for match shooting & cold weather hunting, one 8 oz. tin
Part Number: MINK-OIL
Availability: In Stock
Price: $6.99
Order Quantity:
Shooting patches, .015" cotton, .50 - .59 caliber, per 100, dry
Shooting patches, .015" cotton, .50 - .59 caliber, per 100, dry
Part Number: OX-15-50-D
Availability: In Stock
Price: $3.60
Order Quantity:
Cleaning Patches, 2-1/2" diameter, bag of 100, pure cotton flannel, for .45 to .58 caliber
Cleaning Patches, 2-1/2" diameter, bag of 100, pure cotton flannel, for .45 to .58 caliber
Part Number: OX-CLEAN-58C
Availability: In Stock
Price: $4.19
Order Quantity:
Ramrod, 3/8" hickory, 48" long, brass tip, 10-32 thread
Ramrod, 3/8" hickory, 48" long, brass tip, 10-32 thread
Part Number: RAMROD-6-10-B
Availability: In Stock
Price: $15.99
Order Quantity:
Ramrod for New Englander Rifle, 
3/8" dark brown Delrin nylon, 27" long. Brass tip is threaded 10-32 at rear, with tempered steel ball puller hidden under the .50 caliber cleaning jag at front.

Made in the USA, by Track of the Wolf, Elk River, Minnesota.
Ramrod for New Englander Rifle, 3/8" dark brown Delrin nylon, 27" long. Brass tip is threaded 10-32 at rear, with tempered steel ball puller hidden under the .50 caliber cleaning jag at front. Made in the USA, by Track of the Wolf, Elk River, Minnesota.
Part Number: RAMROD-270-50
Availability: In Stock
Price: $21.99
Order Quantity:
Ramrod for New Englander Rifle, 
3/8" ebony black Delrin nylon, 27" long. Brass tips are threaded 10-32 at rear, 8-32 at front. 
Made by Track of the Wolf, Elk River, Minnesota. We turn the brass tips and assemble the ramrod.
Ramrod for New Englander Rifle, 3/8" ebony black Delrin nylon, 27" long. Brass tips are threaded 10-32 at rear, 8-32 at front. Made by Track of the Wolf, Elk River, Minnesota. We turn the brass tips and assemble the ramrod.
Part Number: RAMROD-270-TC
Availability: In Stock
Price: $17.99
Order Quantity:
Short Starter, patch & ball starter, 7/16" hickory rod for .50 caliber.
Short Starter, patch & ball starter, 7/16" hickory rod for .50 caliber.
Part Number: ST-7
Availability: In Stock
Price: $6.99
Order Quantity:
Patch puller, corkscrew worm, steel, brass base, 10-32 thread
Patch puller, corkscrew worm, steel, brass base, 10-32 thread
Part Number: WORM-CORK-10
Availability: In Stock
Price: $6.59
Order Quantity:
Track's Catalog 18,
Out of Print
Please use our FREE on-line catalog and web site.
Track's Catalog 18, Out of Print Please use our FREE on-line catalog and web site.
Part Number: CATALOG-18
Availability: Book is no longer being printed or produced. Once we sell through our remaining inventory, item will no longer be available.  We will not be getting any more in.
Price: $10.00
  
 
Track of the Wolf, Inc.
18308 Joplin St NW
Elk River, MN 55330-1773

For your convenience you can contact us via our on-line form
Contact the Webmaster if you have any problems with this site.
Privacy Policy        Copyright © 2021Track of the Wolf, Inc.
Accepted Credit Cards