Thompson Center Renegade Hunter,
.54 caliber, 26" barrel,
percussion, walnut stock, iron trim, single trigger,
new-in-box, by Thompson Center Arms
Part Number: AAS-294
Availability: In Stock
Price: $499.00
Order Quantity:
This .54 caliber Thompson Center Renegade Hunter is designed with a single trigger with a wide trigger bow for cold weather hunting. Trimmed in iron furniture the factory finished black walnut stock displays some attractive figure in the buttstock. Offered in new in the box condition with the factory manual. Trigger reach is 13" and this rifle weighs 8.1 pounds.

The .54 caliber barrel is 1" octagon and 26" long. The .54 caliber bore is rifled with a 1 in 48" twist to provide good accuracy with a patched round ball, or a Thompson Center .54 caliber Maxi-ball. As new the bore is bright, clean, and has been well maintained. The barrel is fitted with a bead style front sight and a Thompson Center v-notch adjustable rear sight that is screw adjustable for windage and elevation. We recommend our #BALL-530 Hornady pure lead .530" round ball, #OX-15-50-D Ox Yoke .015" dry patch, #MINK OIL tallow lubricant, 70 grains of #GOEX-FFg black powder, and a No. 11 percussion cap for best accuracy. If hunting big game, in thick brush, try our .54 caliber Maxi ball Increase the powder charge as needed, to achieve best accuracy with this heavier bullet. Recoil will increase, but will not be noticed during the hunt.

The blued steel buttplate is nearly flat to help spread the felt recoil over a large area. The black walnut stock is as-new and displays a good amount of figure through the buttstock. The blue finish on the barrel, triggerguard, and buttplate are all as-new. The factory ramrod is fitted with a blued steel ramrod tip with 10-32 threaded end for accessories. No cheek piece is carved on the T/C Renegade Hunter. The lock is retained by a single lock bolt with round, blued steel washer-style side plate.

The hooked breech allows the barrel to be easily dismounted for cleaning without risk of wetting the stock with water containing black powder residue. To dismount the barrel, put the lock on half cock, withdraw the ramrod, drift the keys past the underlugs, and the barrel can be lifted from the barrel channel for ease of cleaning. Remove the nipple and place the breech end of the barrel in a bucket of soapy water. Run a wet patch down and up the bore, the pumping action will flush all the fouling from the barrel. Once the bore is clean, run a dry patch down the bore to pick up any moisture followed by a oily patch. Dry and oil the exterior then reassemble the rifle.

Our lock view shows the color case hardened percussion lock, factory engraved by Thompson Center. This lock works smoothly, with a strong mainspring, and fly detent. The breech is fitted with a 1/4-28 threaded steel nipple. Order our nipple #RST-S should you require a spare.

Offered in new in the box condition, this is a great example of a Thompson Center Renegade Hunter rifle. Our customers like these well made American guns, for their reliable service, durable reputation, accuracy, and good value. Order it for a ten day visual inspection. You will be delighted. Else if it does not fit you, return it in unfired condition for same-day refund. Postage is your only risk, when you order any one-of-a-kind gun from Track, whether new, used, or antique.

Ready to order? Click VIEW CART in the upper right of the screen, review items and quantities, then click CHECK OUT. Enter your name, address, and billing information for prompt shipment. Or, PRINT your order after entering your address, attach your check or money order, and send it by mail. Shipping cost is displayed after you enter your address.

Our web site displays actual in stock status, up-to-the-minute price, and shipping cost to every address in the USA and MOST OTHER COUNTRIES. International shipping cost for extra long or heavy parcels are determined after we weigh the parcel.

Ten day inspection begins at delivery. Send your approval. Else return it for same day refund, if not delighted. Postage is your only risk.

bullets, .54 caliber, T/C Maxi-Ball, hand cast pure lead, 425 grains, per 20
bullets, .54 caliber, T/C Maxi-Ball, hand cast pure lead, 425 grains, per 20
Part Number: BALL-54-MAXI
Availability: In Stock
Price: $9.99
Order Quantity:
.530" round balls, pure lead, Hornady, per 100
.530" round balls, pure lead, Hornady, per 100
Part Number: BALL-530
Availability: In Stock
Price: $15.29
Order Quantity:
Track's best Black Powder BORE CLEAN Solvent, with flip-top spout
Track's best Black Powder BORE CLEAN Solvent, with flip-top spout
Part Number: BORE-CLEAN
Availability: In Stock
Price: $3.99
Order Quantity:
Ball puller, steel screw, .54 caliber brass collar, 10-32 thread
Ball puller, steel screw, .54 caliber brass collar, 10-32 thread
Part Number: BP-54-10
Availability: In Stock
Price: $3.75
Order Quantity:
Bore brush, bronze, for .54 caliber, 10-32 thread
Bore brush, bronze, for .54 caliber, 10-32 thread
Part Number: BRUSH-54-10
Availability: In Stock
Price: $2.99
Order Quantity:
Brass Capper, for #11 caps, straight line, made in the USA, by Tedd Cash
Brass Capper, for #11 caps, straight line, made in the USA, by Tedd Cash
Part Number: CAPPER-P
Availability: In Stock
Price: $10.99
Order Quantity:
Nipple, Hot Shot® for Thompson Center Hawken & other popular guns, 1/4-28 thread, #11 CCI cap, stainless steel

Cone length: 0.440" Thread journal length: 0.195" Overall length: 0.635" Diameter of base: 0.307"
Nipple, Hot Shot® for Thompson Center Hawken & other popular guns, 1/4-28 thread, #11 CCI cap, stainless steel
  • Cone length: 0.440"
  • Thread journal length: 0.195"
  • Overall length: 0.635"
  • Diameter of base: 0.307"
Part Number: HOT-SHOT-RST
Availability: In Stock
Price: $6.99
Order Quantity:
Jag, jagged cleaning tip, brass, .54 caliber, 3/8" rod, 10-32 thread
Jag, jagged cleaning tip, brass, .54 caliber, 3/8" rod, 10-32 thread
Part Number: JS-54-6-10
Availability: In Stock
Price: $4.25
Order Quantity:
Powder measure, brass, adjustable 0 to 120 grains, with spout
Powder measure, brass, adjustable 0 to 120 grains, with spout
Part Number: MAS-120
Availability: In Stock
Price: $14.99
Order Quantity:
Trapper's MINK OIL TALLOW,
patch grease,
for match shooting & cold weather hunting,
one 8 oz. tin
Trapper's MINK OIL TALLOW, patch grease, for match shooting & cold weather hunting, one 8 oz. tin
Part Number: MINK-OIL
Availability: In Stock
Price: $6.99
Order Quantity:
Shooting patches, .015" cotton, .50 - .59 caliber, per 100, dry
Shooting patches, .015" cotton, .50 - .59 caliber, per 100, dry
Part Number: OX-15-50-D
Availability: In Stock
Price: $3.29
Order Quantity:
Shooting patches, .015" cotton, .50 - .59 caliber, per 100, wonder-lube
Shooting patches, .015" cotton, .50 - .59 caliber, per 100, wonder-lube
Part Number: OX-15-50-W
Availability: In Stock
Price: $6.19
Order Quantity:
Cleaning Patches, 2-1/2" diameter, bag of 100, pure cotton flannel, for .45 to .58 caliber
Cleaning Patches, 2-1/2" diameter, bag of 100, pure cotton flannel, for .45 to .58 caliber
Part Number: OX-CLEAN-58C
Availability: Item is currently sold out.
Price: $3.89
Order Quantity:
  
Ramrod, 3/8" hickory, 48" long, brass tip, 10-32 thread
Ramrod, 3/8" hickory, 48" long, brass tip, 10-32 thread
Part Number: RAMROD-6-10-B
Availability: In Stock
Price: $15.99
Order Quantity:
Ramrod for Thompson Center Renegade, Renegade Hunter, or Big Boar Rifle,
3/8" brown Delrin nylon, 26-5/8" long. Brass tips are threaded 10-32 at rear, 8-32 at front.

Made by Track of the Wolf, in our Elk River, Minnesota, we make the brass tips and assemble the ramrod.
Ramrod for Thompson Center Renegade, Renegade Hunter, or Big Boar Rifle, 3/8" brown Delrin nylon, 26-5/8" long. Brass tips are threaded 10-32 at rear, 8-32 at front. Made by Track of the Wolf, in our Elk River, Minnesota, we make the brass tips and assemble the ramrod.
Part Number: RAMROD-265-TC
Availability: Item is currently sold out.
Price: $17.99
Order Quantity:
  
Short Starter, patch & ball starter, 1/2" wooden rod for .54 and larger calibers.
Short Starter, patch & ball starter, 1/2" wooden rod for .54 and larger calibers.
Part Number: ST-8
Availability: In Stock
Price: $6.99
Order Quantity:
Patch puller, corkscrew worm, steel, brass base, 10-32 thread
Patch puller, corkscrew worm, steel, brass base, 10-32 thread
Part Number: WORM-CORK-10
Availability: In Stock
Price: $6.59
Order Quantity:
Track's Catalog 18,
Out of Print
Please use our FREE on-line catalog and web site.
Track's Catalog 18, Out of Print Please use our FREE on-line catalog and web site.
Part Number: CATALOG-18
Availability: Book is no longer being printed or produced. Once we sell through our remaining inventory, item will no longer be available.  We will not be getting any more in.
Price: $10.00
  
 
Track of the Wolf, Inc.
18308 Joplin St NW
Elk River, MN 55330-1773

For your convenience you can contact us via our on-line form
Contact the Webmaster if you have any problems with this site.
Privacy Policy        Copyright © 2019Track of the Wolf, Inc.
Accepted Credit Cards